Enhanced version with stepped recessed portals, carved doors, niches on the chamfered sides, inlaid friezes, open pavilions, openwork balconies and engraved paving. The 7 parts stay separate: fit the mausoleum and the four minarets onto the base, then the large dome onto the roof. Once assembled, the whole keeps an overall size of about 124 × 112 × 83 mm. Dimensions: 200 × 134 × 68 mm. Printing tips: Print the 7 parts in their provided orientation, in PLA, with 0.12 to 0.16 mm layers, 3 perimeters and 15% infill. A 0.25 mm nozzle will improve the arcades and inlays; a 0.4 mm nozzle is still usable. Add a 3 mm brim to the minarets and slow down the small layers. The railings and pavilions include small bridges; add local supports under the vaults if needed, without automatically filling the small openings with supports that are hard to remove. The lower sockets require bridges of up to 8.5 mm. The colours are multi-material regions, not parts to assemble separately. Deburr the tenons before assembly; gluing is optional. The dimensions given are those of the parts plate, not of the assembled monument.